The Autocut® V system uses an electronically controlled carriage controlled by our CNC computer.  Your combinations of cutting lengths are pre-programmed into the memory of the computer; your forklift operator simply loads the unit of lumber, initiates the cutting procedure and leaves...the system then processes the entire package and brings it to a discharge position...automatically.

 

The Autocut® V system includes a PRELOADING DEVICE as a standard item.  The Preloading Device enables your forklift operator to load your lumber onto the system without waiting on the carriage to be emptied.  The unit is automatically lowered onto the carriage which transports the lumber through to the cutting station and finally onto the off-loading station.

 

The V-series also allows you to program the depth of each cut, allowing you to cut multiple short lengths without having to cut through the bottom layer of lumber.  This system enters the package at an 18 degree canted angle, and remains at this angle until it reaches your programmed depth, then swivels to its horizontal position. The V-series cutting system has a rated top-bottom speed of fifty-five (55) seconds, which is up to 100% faster than other systems available today*. The Autocut® V system comes equipped with our Computerized Control System and includes the following items as standard:

The Autocut® is available with an integrated power package-squeezing system.  This inline package alignment enables you to utilize the latest technology in conjunction with the precision cutting capabilities of the Autocut® system and removes the necessity of of pre-aligning packages prior to loading.  The power squeeze system is specifically designed to align packages with battens attached and ranging from 8’ to 20’ in length.

•    Complete Housing Enclosure around cutting system

•    Analog Cut Counting Meter, permanent and shift reset-able

•    Electronic Trigger Switch Controls

•    Electronic Valves for Hydraulic System

•    Electronically programmable depth adjustable cutting

•    Manual override Electronic Length Measuring System

•    Laser-light Guide for cutting

•    Front Control Center with complete non-slip operator’s platform and stairs

Package Crosscut Saws for Lumber Crosscutting with Absolute Precision
Package Crosscut Saws for Lumber Crosscutting with Absolute Precision
Package Crosscut Saws for Lumber Crosscutting with Absolute Precision
Package Crosscut Saws for Lumber Crosscutting with Absolute Precision
Package Crosscut Saws for Lumber Crosscutting with Absolute Precision
HOLTEC PRECISION CROSSCUT SYSTEMS

Designed to cut whole bunks of lumber to length in less than 60 seconds with an accuracy of +/-1mm (.040”) and leave a planer finish.

It's that simple.

TRANSCUT® II PORTABLE

TRANSCUT® II STATION

SELECUT® V SERIES

AUTOCUT® V SERIES

MAXIMUS® V SERIES

*All specifications and pricing are subject to change without notice. HOLTEC cannot be held responsible for errors in typography or photography. Photographs may show systems with optional accessories. On-site service may not be available in certain remote locations.  Proper maintenance procedures are essential for accuracy and longevity, and accuracy results are based on HOLTEC installed systems using Scratcher® chain technology. Stroke speed may vary based on specie and dimension of lumber. HOLTEC, TRANSCUT, SELECUT, AUTOCUT & MAXIMUS are registered trademarks of HOLTEC GmbH. All other trademarks are the property of their respective owners. Warranty and guarantee terms are subject to limitations and delivery or installation to certain remote locations may incur additional charges.Financing is arranged through a third-party vendor and is subject to credit approval.  Please contact us for complete details.  ©2018 HOLTEC (U.S.A.) Corporation. All rights reserved.